Diamond Vinyl Decking

Diamond Vinyl Decking - long lasting beauty with low maintenance, an investment that pays dividends plus adds value to your home. It is heavy duty , quality vinyl decking you can rely on. No splinters or painting!

Deck & Roof System in One
Lifetime Limited Warranty
No Chipping, Cracking or Splinters
No Static Electric
100% Vinyl Throughout
Maintenance Free
Installs 5 times faster than other decks
Cool To The Touch
Color Clear Through

Patented Diamond Drainage Surface System
No Beating, Jumping or Hammering together
Pre-drilled Screw Down Flange
Installs on 16" Centers
No Clips, Spacers or Brackets - EZ Installation
Special Stainless Steel Screws Supplied That Allows Deck Movement
Patented Diamond Seal
Water-tight

EZ Installation:

1. Start installing your new deck by screwing down the Start Strip or U-Channel against the House. NOTE: Caulk 2 Places.

2. Insert your first piece of deck into starter or U-Channel and screw down.

3. Insert 2nd piece of deck into back side of first piece and snap down into place.

4. Continue until deck surface is completed.

5. Install finish U-Channel around edges of deck to give finished look.

Step # 1. - Framework: Framework must be cut back 1 ½" - 2" which will allow deck to overhang. Framework must be pitched 1" per 10 feet to allow for water runoff. Floor joists are to be installed 16" O/C.

Step # 2. - If your deck is running parallel with the house use starter strip, caulking back pushing against house and screwing down through pre-drilled holes. If C-Channel is being used and deck is running away from the house, caulk back of C-Channel and inside, remove ¼" rib and caulk inside C-Channel then screw to house.

Step # 3. - Insert 1st piece of decking either into starter strip or slide into C-Channel allowing 1 ½" - 2" overhang. Measure and square up deck so overhang is equal on both sides & front. Insert screws in both ends and snap chalk line so 1st piece is straight. Insert balance of screws in 1st piece, then simply drop next piece in and lock down and continue till surface of deck is complete. Fill Gutter channel at house with caulk approx. 1" so water cannot run through where deck and gutter channel meet at house.

Step # 4. - Finish deck by installing C-Channel around outside perimeter of deck.